Hey guys, just got my hands on a 66 chevy II. Trying to put in new vent window locks. I can't get the locking pin in place, it too wide. Any suggestions? drill it out a bit ?
Thanks

 

Get a smaller pin. Use a roll pin if you have to.

 

Does it have the spring behind it? Is it a new restro part?

 

Thank you

 

yes new resto part. No spring, it's just a little metal tube with a split down it's full length

 

Hey gang,
I have an angry lifter on the driver side of 350. Pulled valve covers. Found water/coolant cream on roof of valve cover on pass side. Otherwise, oil looks good. Had a recent overheat. I know it can be a head gasket or cracked block. My question is , why would it happen on just one side? Wouldn't cream get over to other side too? Thank You

 

TAURUS25 PLEASE read the RED letters at the top of this page and start a new topic in the proper section. You will get lots of help that way!

 

Did that. I've been a member, started last month. Site made me re-subscribe. Now it's a total PIA to post a question. How many times do I have enter my info in the new member section?
Sorry, but I'm getting frustrated ? TY