96 Tahoe back door hinge pin removal???
#1
96 Tahoe back door hinge pin removal???
Hello everyone,
I have a 96 tahoe with barn doors in the back. My left door got damaged and I want to replace it. There is a top pin and bottom pin on the door. I tried knocking them out, tried an air punch, tried heating them up.
Does any have an idea on how these pins come out??? I assume that they are pressed in.
Any information would be very helpful...
Thank You,
Ryan
I have a 96 tahoe with barn doors in the back. My left door got damaged and I want to replace it. There is a top pin and bottom pin on the door. I tried knocking them out, tried an air punch, tried heating them up.
Does any have an idea on how these pins come out??? I assume that they are pressed in.
Any information would be very helpful...
Thank You,
Ryan
#3
Back door hinge pin removal
I ended up cutting the pin to remove the door from the truck. Then I grinded off the head of the pin. Next I started with a small drill bit. I drilled through the head of the pin. I went through several different drill bits to slowly open the hole up. Once I just the hole as big as I could without ruinning the door hinge. I punched the rest of the pin out. It took me about an hour per pin. Not fun and don't ever want to do it again....
Thread
Thread Starter
Forum
Replies
Last Post