Maybe it will get better after time when it fully cures. I probably should have waited longer than 10 hours to install it! However, I get anxious!

It isnt the end pieces that dont flex. It is like the area where the end attaches to the big bar. The entire endsection! That area! I probably just need to let it dry a little and then go move it aroundnumerous times hopefully loosing it up.That or maybe some lube right on that area!To much friction (paint)in between the contact area! I dont really mind, I wont use it very often. But it doesnt function 100% effectively!

 

Thanks for this info

 

I scraped the paint from the tabs that insert into the slots for that joint. I did tape it off but figured it would be easier to scrape it after than to get the perfect tape job. So I removed the tape and painted it all only to scrape the paint before re-assembly.

Maybe you can take it apart and remove some paint. Wait a little to let the paint cure first though.

 

Just tell them Landon sent you. He will take care of you!

 

I think that is what I need to do! That is the only joint that I have any problems with! By the way, you left that out of your "how to."

 

Gave you my number...TOO much info to get it all in writing. Sorry[sm=oopssign.gif]

 

No biggie! I actually took it off and trimmed the paint off the areas where it rubbed. You can actually see the spots where it rubs. I am going to now touch up a couple spots, then let it dry. I will leave it off longer this time! HOwever, I tried it after I removed the paint causing the rubbing and it worked perfectly. SO it will be fixed once I finally get it painted to my perfection. Just a couple very minor spots I wanted to touch up. So back to the drawing board! Will be done in a few hours! Thanks again for your help!

 

#2 & #3 have a backup camera. Wiper looks good too.

 

Thanks Biglg, one is on the way to me.